Roof Repairs El PasoRoof repair across El Paso and the Borderland Call (915) 555-0100

Metal roofing in El Paso

Metal roofing in El Paso covers installing and repairing standing seam and exposed-fastener panel roofs on homes, farm buildings and manufactured homes. Metal handles sun and wind well and can use reflective finishes. Most repairs deal with loose or rusted fasteners, failed sealant at laps and flashing, and panels damaged by wind or hail.

Call (915) 555-0100

Lines open 24/7. Your call goes to an independent roofer who works in your area.

Roofer installing a standing seam metal roof panel on a ranch home

Metal roofs around El Paso

Metal is common on farmhouses and outbuildings in the valleys around Clint, Fabens and Canutillo, on manufactured homes in Chaparral and Homestead Meadows, and on a growing number of modern and ranch-style homes across the city. It is light, long-lived and stands up well to desert sun when the finish is good.

Types of metal roof

Standing seam and exposed-fastener metal roofs compared
FeatureStanding seamExposed-fastener panels
How it is fixedHidden clips under raised seamsScrews with rubber washers through the panel
MovementPanels expand and contract freelyScrews work loose as metal moves with heat
Typical useHomes, low-slope residentialBarns, sheds, manufactured homes, budget roofs
MaintenanceLow; check trim and sealantCheck and replace screws and washers periodically
PriceHigherLower

Common metal roof problems

  • Loose or backed-out screws. Daily heating and cooling works fasteners loose, and washers dry out in the sun.
  • Leaking laps and seams. Sealant between overlapping panels breaks down.
  • Rust at cut edges, scratches and around fasteners, especially on older galvanised roofs.
  • Flashing failures at walls, chimneys, vents and ridge caps.
  • Wind damage to edge trim and panels that weren't fastened to spec.
  • Hail dents. Often cosmetic, but they can crack finishes.

How metal roof repairs are done

For fasteners, the roofer replaces worn screws with new ones, sometimes a size up so they bite into fresh material, with new sealing washers. Laps are cleaned and resealed with butyl tape or a compatible sealant. Rusted areas are wire-brushed, primed and coated, or the panel is replaced if it is rusted through. On older exposed-fastener roofs, a silicone or acrylic restoration coating over the whole roof, after fastener and seam work, can extend its life. See roof coating.

Installing a new metal roof

A new metal roof involves removing the old roof or installing over it where allowed, checking the deck, adding underlayment, then installing panels, trim and flashing to the manufacturer's spacing. In El Paso wind, correct fastening and edge details matter more than almost anything else.

What affects cost and time

  • Panel type, gauge and finish
  • Roof size, pitch and complexity
  • Whether the old roof is removed
  • Trim, flashing and the extra edge fastening needed for wind
  • Rust or deck repairs

Before the roofer comes

Note where leaks show up and whether they are worse after hot days followed by rain, which points to fasteners. Photograph any visible rust or lifted panels from the ground.

When it is urgent

Panels peeled back by wind can catch the next gust and tear further. Ask for emergency roof repair to secure them.

Metal roofs on manufactured homes

Many manufactured homes around El Paso have low, slightly arched metal roofs. They expand and contract a lot in desert heat, and the seams and fasteners loosen over time, so small leaks keep returning in different places. Two common solutions are a restoration coating, applied after every seam and fastener has been fixed, and a roof-over, where light framing and a new pitched roof are built over the old one. A roof-over adds insulation and sheds water better, but it costs more. Ask the roofer to explain which suits the home and its framing.

Common questions

Are metal roofs good in El Paso heat?

Metal handles heat and UV well, and light-coloured or reflective finishes reduce heat gain. Good underlayment and ventilation also matter.

Why does my metal roof leak around the screws?

Heat makes metal panels expand and contract daily, which loosens screws and wears out the rubber washers. Replacing fasteners and washers usually fixes it.

Is a metal roof noisy in a monsoon storm?

Rain and hail are louder on metal over open framing, like a barn. On a home with solid decking and insulation, the difference is usually modest.

Can an old metal roof be coated instead of replaced?

Often yes, if the panels are structurally sound. Fasteners and seams are repaired first, then a restoration coating is applied.

Talk to a roofer about your roof today

Calls are free and lines are open 24 hours a day. Tell the provider what you are seeing, where the property is and how urgent it is, and they will explain the next step.

Call (915) 555-0100

Call (915) 555-0100

Talk to a local roofer now

Leak, storm damage or just a question about your roof? Lines are open 24/7 and the call is free.

Call (915) 555-0100